Best answer

How to delay pulling data or refresh it after it’s been pulled?

  • 29 July 2021
  • 4 replies


I am currently sending leads from a lead source to my CRM using a zap. When a lead comes into the source the zap is triggered, and it gets pushed out to my CRM where the new lead is created. The zap filters (and either runs/or does not run) base don a tag that the lead source adds (buyer / Seller). For example if a new seller leads comes in the “Seller” zap will run because the lead has the “Seller” tag (and the “Buyer” zap will not run, because the lead does not have the buyer zap).



Here is the issue. When a new lead is created in my lead source a tag is added by the lead source AFTER the new lead is created. SO when the zap fires the new lead does not have the “Buyer/Seller” tag yet. I created a delay in the zap, but I do not know how to tell zapier to refresh the lead data to check for the new tag. 

New Lead>Zap Fires (lead did not have the tag the second it was created)>leads go to the CRM, but get assigned incorrectly.

I need something like this

New Lead>Zap Triggered>Delay>Zap pulls new info for the lead (and gets the tag)>Zap Pushes to CRM.


Any ideas?


Best answer by Troy Tessalone 29 July 2021, 20:32

View original

This post has been closed for comments. Please create a new post if you need help or have a question about this topic.

4 replies

Userlevel 7
Badge +14


StreetText only has these 2 triggers available and 0 actions.

Try this…

If you use the trigger “New Lead Added to an Automation” and you have a separate automation per Tag, then you can filter based on the Automation.


Does Zapier have a find/search step that can be configured to go back and look for info from the source again? When I try to add StreetText a second time it is greyed out and says no actions available. 

The sending app is Street Text.  

I think that’s what I needed (the find/search step). I’ll take a look at that now. 

Userlevel 7
Badge +14

Hi @micaholson 

What app is sending the lead data for the Zap trigger?

You’d need to add a Find/Search step after the Delay to get the most recent data for the lead.