I have only created the trigger and transcription steps.I believe the audio file is being set to Whisper but I am only receiving ………... as content for the transcript.
The trigger is for a new audio file in a folder.
The test file that was used was MP3 audio - 13.7 MB.
It appears as though the file is being sent.
The action is just to Create the Transcription.
This is the content that is returned.
+14
Hi
Good question.
Perhaps try adding a prompt?
So when I added the prompt, it then gave me a 504 Gateway Time-out error.
So, I tried a smaller-sized file, and I was able to get a transcript back (although just to see, I tried the smaller sized file without the prompt and it also gave me a transcript).
So the prompt did seem to do something, but I am not sure what. Below are the results depending on the file size and use of a prompt.
| File Size | With Prompt | No Prompt |
|---|---|---|
| ~13 MB | 504 Gateway Time-out | ……………………….. |
| ~1 MB | Transcript | Transcript |
+14
You may have to do additional testing to determine if a certain MAX file size can be used. (e.g. 5 MB vs 10 MB)
Enter your username or e-mail address. We'll send you an e-mail with instructions to reset your password.
