[PIPEDRIVE] [ NEW LEAD] [SEND EMAIL-OUTLOOK]
Hi!
Do you experience some problems with zapier recently? in my case, trigger isn’t pulling the data from our pipedrive account, sees only 4 leads from 2020 and therefore I cant finish my automation that would send the email’s away.
Best answer by christina.d
Hi Community squad! 👋🏽 Swinging by to summarize some of the recommendations for troubleshooting here:
If I understand the challenge correctly, you’re trying to pull more sample data in the trigger?
This works as expected. You can only pull the last three. Can you try adding a new lead to Pipedrive and then try to load more data?
Some other steps to try from
+7Hello
Did you cross check if that was the Pipedrive Account that is connected inside your Zapier Automation?
Also try using Zapier in a Private Mode or Incognito Window of your browser and check if you are able to see all the leads from your pipedrive account or not.
If still issue persists reach out to Zapier Support they will be able to look into your account
+6Hi
If I understand the challenge correctly, you’re trying to pull more sample data in the trigger?
This works as expected. You can only pull the last three. Can you try adding a new lead to Pipedrive and then try to load more data?
Hey
+9Hi Community squad! 👋🏽 Swinging by to summarize some of the recommendations for troubleshooting here:
If I understand the challenge correctly, you’re trying to pull more sample data in the trigger?
This works as expected. You can only pull the last three. Can you try adding a new lead to Pipedrive and then try to load more data?
Some other steps to try from
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
