Hey,
I’m using the lookup option in the zapier utilities in order to convert values to a readable format for my destination app.
But when I go to enter that converted value in a different step then the only option available to pull in is the actual lookup key, which contains only the one sample value, not the converted value, so the format is correct, its just not the right value. I can’t see how I can add the custom value to a field in the step.
Help appreciated
Mark
Best answer by DanversBest answer by Danvers
Hi
The first thing to check is whether you tested the Lookup step. If you tested the step, the output should be the value that was found in the lookup table rather than input from the previous step. In the next step of your Zap, make sure that you are choosing the output of the Formatter step and not the original value from the previous step. I hope that makes sense, let me know if you have any questions!
+12Hi
The first thing to check is whether you tested the Lookup step. If you tested the step, the output should be the value that was found in the lookup table rather than input from the previous step. In the next step of your Zap, make sure that you are choosing the output of the Formatter step and not the original value from the previous step. I hope that makes sense, let me know if you have any questions!
Hey,
No worries on getting back to me now. Yeah, I figured it out eventually
Thanks,
Mark
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
