I am using a row lookup so I can update a specific row. The looup actually finds/retrieves the row just fine. It’s when I go to update the row based on the Row ID it falls apart.
There is NO ID field that shows up for me to select. There are two Row fields that show up in the same list which is weird too.
Why is the ID field not showing up for me to select so I can update the row I just looked up?
Best answer by Troy Tessalone
Hi
Alternatively you can use the Row data point.
To help clarify, here is the test data coming back from the lookup. I can see ID here, but when I go to choose it, not there.
+14Hi
Alternatively you can use the Row data point.
This did the trick. Feels a bit untrustworthy, but works. Thanks for the reply.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.
